The VMPTRI Tri-Pump is also a pump drive module with three pump heads driven as a single unit.  In the standard setup, the three pump heads are driven out-of-phase resulting in a pulseless flow output.  The pumps can also be set up to run in-phase as individual pumps allowing very high flow rates and or mixing or blending of fluid in a fixed ratio of 1:1x3. 

The unit requires a 24 volt DC power source and remote control (TSI touch screen, computer, or PLC) to run.  After a run-program is initiated the remote controller may be disconnected, and the VMPTRI will continue to run the preset program.

Allows simultaneous setup and control of up to 16 VMPOEM and/or VMPTRI pumps.  All parameters, volume, number of revolutions, speed, etc. can be programmed via the TSI.

.